| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE POWER CORD FROM THE CORD HOOK.
|
| 2 |
|
UNHOOK THE VAC HOSE FROM THE HOSE HOOK.
|
| 3 |
|
SLIDE UP ON THE BAG COVER LATCH. PULL THE BAG COVER FROM THE MACHINE.
|
| 4 |
|
PUSH IN ON THE RED LEVER ON THE RIGHT SIDE TO UNLOCK THE BAG.
|
| 5 |
|
PULL THE BAG DOWN OFF THE INTAKE HOSE.
|
| 6 |
|
LOCATE THE 5 SCREWS ON THE BACK OF THE VAC (VISIBLE AFTER REMOVING THE BAG). REMOVE THE 5 SCREWS.
| Screwdriver-phillips |
|
|
| 7 |
|
REMOVE THE SCREW HOLDING THE BRUSH TOOL HOLDER.
| Screwdriver-phillips |
|
|
| 8 |
|
PULL TO REMOVE THE HANDLE ASSEMBLY FROM THE VAC
|
| 9 |
|
LAY THE HANDLE ASSEMBLY DOWN AND REMOVE THE 4 SCREWS
| Screwdriver-phillips |
|
|
| 10 |
|
REMOVE THE BACK PANEL ON THE HANDLE ASSEMBLY
|
| 11 |
|
LOCATE THE SWITCH. THERE ARE 2 BLUE WIRES AND 1 GREEN/YELLOW WIRE.
|
| 12 |
|
LOCATE THE CONNECTOR AT THE BOTTOM OF THE HANDLE. SLIDE THE COVER OFF THE CONNECTOR. THERE ARE 3 WIRES, 2 BLUE AND 1 GREEN/YELLOW.
|
| 13 |
|
LOOSEN THE SCREW IN THE TERMINAL BLOCK FOR THE BAD WIRE.
| Screwdriver-flat tip |
|
|
| 14 |
|
FOLLOW THE BAD WIRE TO THE CONNECTOR AT THE BOTTOM OF THE HANDLE. PULL UP ON WIRE CONNECTOR TO REMOVE IT FROM ITS SLOT. REPLACE THE WIRE AND/OR CONNECTOR.
| Wire crimper |
|
|